Whatever’s moving through your operation, there’s a hose, fitting, or valve keeping it contained. H.O.W. Rubber is the industrial hose supplier that stocks all of it: pipe fittings, clamps, valves, brass adapters, sheet rubber, and pressure gauges, all in one place. You don’t need to call three different suppliers to build one system. Bring us what you’re working on and we’ll help you spec it, source it, or fix it.
We stock hose for the systems industrial and municipal crews rely on every day:
Suction and discharge hose gets pulled constantly for water and chemical transfer, plus bulk material handling. We keep enough on hand that you’re not waiting on a truck to show up before your line’s back running.
A lot of what comes through the door is industrial hose repair. Usually that’s a worn section or a bad crimp. Sometimes it’s a fitting that’s outlived the hose it’s attached to. We rebuild and reassemble hose in-house rather than sending it out. A section gets replaced the same trip, instead of sitting on a shelf waiting its turn.
We stock four clamp styles:
The wrong clamp on the right hose is still a comeback waiting to happen. Match the clamp to the pressure and vibration the line sees, not just whatever’s closest on the shelf.
A stuck foot valve or a butterfly valve that won’t seal is usually just a maintenance call. We stock the valve styles plant and facility crews replace most often, plus the ball and gate valves municipal utility work calls for.
Our pipe fittings lineup, rated to Schedule 40 spec:
Fire and water transfer crews mixing OKC and NST thread on the same line are one of our more common walk-ins. Matching the two is usually a five-minute fix once we know what’s on each end.
Compounds we cut for conveyor skirting and wear lining, chutes and bins included:
If a conveyor’s throwing material past the belt edge, or wearing through at a transfer point, skirt board and wear-liner rubber is usually the fix. We stock the common compounds rather than special-ordering them.
Brass adapters bridge mismatched threads and fitting styles. We keep enough variety on hand to connect most combinations without a special order.
Liquid filled, dry, or vacuum, sized to whatever hydraulic or industrial system you’re monitoring.
Call (405) 236-1222 or stop by 2640 SW 15th Street, Oklahoma City, OK. We’re open 8:00 AM – 5:00 PM, Monday – Friday.
If you’re not sure which category your part falls into, that’s fine. Bring it in, tell us what’s wrong, and we’ll figure out what it needs.